Description

Charge and care for compatible Widex hearing aids with the Widex Charge N Clean Charger WPC101, an all-in-one charging unit that charges, dries, and provides UC-C maintenance in the same cycle. The charging bays hold each hearing aid securely; its receivers sit inside the dedicated maintenance space. You simply place the hearing aids inside, position the receivers correctly, and close the lid. For a full charge, it takes about four hours, and for a quick top-up, 30-minutes of charging provides approximately four hours of hearing aid use.

The drying and UV-C maintenance cycle runs during charging and takes 30 minutes. A separate indicator light displays the process of this cycle. If you open the lid, it pauses the maintenance process, but charging continues, and the maintenance cycle restarts after you close the lid. It has separate charging indicators that display the battery status of each hearing aid; flashing green shows below 40% charge, glowing green shows a level above 40% and solid green confirms a full charge.

The hearing aid will automatically shut off after being placed in the charger and turn on again shortly after you remove it. As this charger does not have an internal power bank, you must use a suitable power connection during use.

Key features:

Charges, dries and maintains hearing aids
UV-C treatment and drying during charging
30-minute maintenance cycle
Full charge in approximately four hours
30-minute charge provides approximately four hours of use
Charges one or both hearing aids simultaneously
Dedicated compartment for maintenance of receivers
LED light indicators for showing status of charging or maintenance
Hinged lid and micro-USB power connection

Compatible with:

Widex Moment sRIC R D
Widex Moment mRIC R D
Widex Magnify mRIC R D

Note: Check your hearing aid compatibility before ordering. Compatibility is based on the hearing aid model, not all Widex hearing aids.

How to use:

Connect the cable from the power adaptor to the charger and the wall outlet.
Wait for the indicator lights to flash five times, and then the charger is ready for use.
Place the left and right hearing aids into their respective charging bays.
Position the receiver into the maintenance compartment.
Close the lid to start the charging and maintenance cycle.
Check the indicator lights for the status of the charging and maintenance cycle.
Wait for a solid green charging light to confirm a full charge.
Open the lid and remove the hearing aids, holding their body; avoid pulling the receiver wire.
Wait a few seconds for the hearing aids to switch on.

Why use this charger?

This Wide Charge N Clean WPC101 combines daily charging and hearing aid care in one unit. Its automatic drying and UV-C maintenance cycle reduce the need for a separate drying device, while the LED light makes the stage easy to follow.